WorkBench с APDL командами

Подскажите пожалуйста, каким образом можно сделать код рабочим. (работаю в воркбенч)

APDL commands:

!   Commands inserted into this file will be executed just prior to the ANSYS SOLVE command.
!   These commands may supersede command settings set by Workbench.

!   Active UNIT system in Workbench when this object was created:  Metric (mm, kg, N, s, mV, mA)
!   NOTE:  Any data that requires units (such as mass) is assumed to be in the consistent solver unit system.
!                See Solving Units in the help system for more information.

! Be careful with UNITS because of the material propertites.  <<<==========
! It is assumed that NO SYMMETRY effects are in this model.
!
fini
/prep7
*get,typemax,ETYP,,NUM,MAX    ! max defined element type
*get,realmax,RCON,,NUM,MAX    ! max defined real constant
*get,mat_max,MAT,,NUM,MAX     ! max defined material
*get,nodemax,NODE,,NUM,MAX    ! highest numbered node in model
! Create a new higher number for element type, real, and material
newnode=nodemax+1000          ! number for pressure node for HSFLD242
newnumber=typemax+1
*if,realmax,ge,newnumber,then
   newnumber=realmax+1
*endif
*if,mat_max,ge,newnumber,then
   newnumber=mat_max+1
*endif
et,newnumber,HSFLD242         ! 3-D Hydrostatic Fluid Element
keyopt,newnumber,1,0          ! UX, UY, UZ, plus HDSP at pressure node
keyopt,newnumber,5,1          ! Fluid mass calculated based on the volume of the fluid element
keyopt,newnumber,6,1          ! Incompressible
mp,dens,newnumber,1.0e-9      ! Density of Water, kg/mm^3/1000
r,newnumber,0.10156    
type,newnumber,3
mat,newnumber,2
real,newnumber,3
d,1,hdsp,0.2482128

cmsel,s,Inside_Faces          ! Select nodes on interior
esln                          ! Select elements that touch these nodes
n,newnode,0,0,0             ! Pressure node at 0,0,0 (automatically moved to centroid?)
ESURF,newnode                 ! ESURF HSFLD242 elements over solid element faces
                              !    Extra node "newnode" with ESURF with HSFLD242
allsel
fini
/solu                         ! return to solving

Рабочий, тока не могу понять, почему не проявляется давление газа - r,newnumber,0.10156.